WET INSTALLATION PREP For the wet installation meWET INSTALLATION SLIP & TACK Once the surface is prepared, spray the slip solution generously on both the vehicle surface and the adhesive side of the PPF. Carefully position the film over the desired area, ensuring that it aligns correctly. Use a squeegee to push out any excess solution and air bubbles, starting from the center and working your way outwards. To create a strong bond, use your electric sprayer with your tack solution (we recommend hot distilled water, no alcohol) to wash away any remaining installation gel solution and squeegee the area again. This technique will help achieve a smooth application and reduce the risk of imperfections.thod, it is essential to prepare the surface properly. Begin by cleaning the vehicle's surface thoroughly to remove any dirt, coatings, wax, and imperfections. Next, mix a solution of water and Jelly Fresh to create a slippery installation gel. This solution will allow the film to slide into position before it adheres to the surface.
